Menu 32. Show All Alarms.
The alarm log is a global log containing all the alarms/tamper etc.for the complete system.The alarm log can
have up to max 100 events. When the log is full the oldest event will be overwritten.
It is possible to call an event number by keying in the event number, or the next event number by using the
↓
-
key. The latest (newest) event is displayed first (001). To return to the Menu 32 the
C
- key is used.
The following events will be logged in the alarm log:
Text Explanation Parameters
HOLD-UP
READ.SAB
SART SAB
D.FORCED
D.HELD
BATT ERR
SYS. ERR
MAIN ERR
EXT. ALM
CARD BLK
CARD ILL
CODE MIS
REF.ZONE
NEW DATB
SER.CARD
POWER
SYS PROG
D.P.OPEN
D.NORMAL
READ.INIT
Hold-up code used
Reader sabotage
S-ART sabotage
Door forced open
Door held
Battery fault
System fault
Mains fault 1 hour
External alarm system in alarm
Blocked card used
Not-released card used
Code misuse (10 times)
Anti Passback zone conflict
Database changed or reader initialized
Service card used
Power down
System programming menu 51-57 done
Door set permanent open
Door set in normal again
Reader initialized
Card no.(C) Reader no.(R)
Reader no.(R)
Reader no.(R) S-ART no.
Reader no.(R)
Reader no.(R)
Reader no.(R)
Reader no.(R) Error no.(E)
Reader no.(R)
Reader no.(R) S-ART no.
Card no.(C) Reader no.(R)
Card no.(C) Reader no.(R)
Card no.(C) Reader no.(R)
Card no. (C) Zone no. (Z)
Reader no.(R)
Card no.(C) Reader no.(R)
Reader no.(R)
Reader no.(R) Menu no.(M)
Reader no.(R)
Reader no.(R)
Reader no.(R)
For each event time and date will be shown.
Menu 33. Show Program Version and company code no.
In this menu it is possible to see information about the software version, the company code programmed in the
system, Options selected for the reader and the Mode programmed for the reader.
To Next Page
Loading...