The week programs no. 0 - 30 are used to define access rights for the personnel groups. Week program
0 to 30
are global
meaning they are common for all readers and program
31 to 34 are local
for each reader where
they are programmed.
Week time program no. 3 – 30: One of the following functions can be allocated to the time periods:
FNC. 0. No access
FNC. 1. Access with PIN code
FNC. 2. Access without PIN code
FNC. 3. Toggle function with code (permanent release until the card is swept through
and PIN-code keyed in, then back to normal door function, etc)
FNC. 4. Toggle function without code (permanent release until the card is swept
through, then back to normal door function, etc)
FNC. 5-9. Reserved for new functions
Week time program no. 31 (Log definition): One of the following functions can be allocated to the time periods:
FNC. 10. No log
FNC. 11. Alarm log only. In this case the local event log will only contain local alarms.
FNC. 12. Log all except passage through door
FNC. 13. Log all except passage through door and log door passage with use of code
FNC. 14. Log all except those limitations, which are defined in the database of the
personnel group.
FNC. 15. Log all
FNC. 16-19. Reserved for new functions.
Week time program no. 32 and 33: One of the following functions can be allocated to the time periods:
FNC. 20. Input Softtype 76/77 inactive.
FNC. 21. Input Softtype 76/77 active.
FNC. 22-29. Reserved for new functions.
Week time program no. 34: One of the following functions can be allocated to the time periods:
FNC. 30. Door permanent open during specified time period.
FNC. 31. Door permanent closed during specified time period.
FNC. 32. Door in normal function during specified time period.
FNC. 33. Card reader accepts code without card during the specified time period .The
100 card nos. which can be programmed to used code only is preprogrammed
to use the nos. 1000 to 1099. This range can be changed by adding the
following line in the AIMS.INI file (in the section
[THOR AIMS]
):
Cardno Offset=2000
The off-set no. must always be an equal thousand number.
FNC. 34-39. Reserved for new functions.
A week time program includes time limitations for all the 7 week days and 2 special days. The week day is
generally determined by the built in clock with calendar, but if the day is defined as a special day, the week day is
determined from the holiday days list.
1.9.4 Holidays list.
A special days list is a list of days, for example holidays, with specific restrictions. For each date in the special
days list, a specific day type is assigned (week day or special day), which will be enforced on that specific date.
To Next Page
Loading...