4.1 Operating facilities.
The reader has 4 special Status LED indicators, which can be controlled by THOR intrusion, when the reader is
part of a THOR integrated system. The LED indicators will in this case function as described in the THOR
Intrusion User Manual.
The LED indicators can also be controlled by the card reader to indicate alarm, fault, set status etc.
The following will be indicated on the LED's:
Green power lamp:
Steady light indicates Mains OK. Flashing indicates Mains Fault.
Red alarm lamp:
Will indicate when an alarm input softtype is active, f. ex. an external intrusion system with alarm
connection to the THOR access control system. The lamp is active as long as the input softtype is
active. The alarm message type can be seen in the alarm log.
Red external alarm lamp:
Only available on the 90T RKP reader types. Only used in THOR intrusion integrated systems.
Yellow system fault lamp:
Indicates Battery fault or System fault. The lamp is active as long as the fault exists. The fault type
can be seen in the alarm log.
Yellow set lamp:
Indicates the set/unset status of an intrusion system connected to the reader. Will only be activated
when a card is read and accepted. Will also indicate the status when the system is used with "first
in" / "last out" cards.
To Next Page