2.6.5.2 Connections.
Please note that the Single zone Controller 90T CSC
must
be used together with the Loop Coupler 90T CLC.
2.6.6 Test equipment.
To help the installer during the installation, test and commissioning of the systems Cotag has developed a series
of test instruments. Specially two test instruments can be recommended to use, if the Cotag antennas are
installed in difficult situations etc.
Please contact Hi Sec International for further details if wanted.
2.6.6.1 Installation Alignment Meter.
The installation alignment meter is a portable, battery powered instrument developed for site survey and the
installation and alignment of Cotag equipment. It can be used for noise measurement, noise source location,
metal detection and the tuning of aerials in situations where appropriate. The meter is supplied complete with
noise probe and accessories.
2.6.6.2 Field meter.
The field meter is a test instrument used for measuring the interrogation field strength during the commissioning
and maintenance of a Cotag system. It is battery powered and consists of a hand-held display unit connected to
a sensor probe by screened cable. The meter features single button operation and battery level indication.
To Next Page
Loading...