One reader - 2 doors:
If the reader option bit 13 is set to "0" (no interlocking function) then the input / output softtypes for Door 2 can be
used as indicated in the small example below. In this example the reader is used to control two doors, which are
place on each side of the reader and both close to the reader.
When programming the rights for the personnel groups on each reader
(only possible from the AIMS
software)
it must be specified if the personnel group has access to Door 1 (primary door), Door 2 (secondary
door) or both doors.
The following is a table showing the softtypes to be used for the different S-ART inputs/outputs:
Door no. Door contact Exit p.b. Door release
(
input
softtype)
Door release
(
output
softtype)
1 Ityp 30 Ityp 32 Ityp 80 Otyp 83
2 Ityp 31 Ityp 40 Ityp 81 Otyp 84
To Next Page
Loading...