9.4 Message Reference
147
99
Continuing Execution of Commands after Command Processing Ends
Syntax
(Command)
∗WAI
The instrument goes into waiting state until the operation of the previ-
ous command has been completed.
Error
If the data parameters are set after this command, a command error occurs.
Note The ∗WAI command is accepted by the 9518-02 interface because it is a standard
command as specified by IEEE-488.2 1987. However, since all of the commands
specific to the 3174 (3174-01) are in any case sequential commands, using this
∗
WAI command never has any effect.
To Next Page
Loading...
