Hioki 3174 - FAIL Hold

6.2 Display Hold (Hold Function)
86
See "Appendix2 List of Optional Functions" (p. A5)
Retains the value shown when the test has ended and FAIL is displayed. To
return to the READY state, press the STOP key, which will cancel the Hold.
When the FAIL hold function is disabled, the test result is displayed for 0.3 sec-
onds, and the instrument reverts to the READY state.
See "6.5 Limiting the FAIL Hold Cancellation (FAIL mode)" (p. 90)
6.2.2 FAIL Hold
1.
( is lit)
Make sure the lamp is lit on the screen.
* will not be displayed during the Double Action setting.
2.
Press the STOP key while holding down the SHIFT key to display the
optional screen (page 1).
3.
Press the key to move the flashing cursor to the position of FAIL hold.
4.
Press the / keys to select the mode.
0: FAIL hold is not used
1: FAIL hold is used (Initial setting)
5.
Press the STOP key while holding down the SHIFT key to complete the
setting value.
The instrument reverts to the READY state.
To continue to the setting for the next item, press the key.
SHIFT
STOP
+
or
<Ex.> Select Without FAIL hold.
SHIFT
STOP
+