Hioki 3174 - Command Reference List

9.3 Communication Methods
138
Common Commands (RS-232C/ GP-IB)
Specific Commands (RS-232C/ GP-IB)
9.3.7 Command Reference List
Command Explanation
Ref
page
∗CLS
Clears the status byte register and the event registers. 143
∗
ESR?
Queries the contents of the standard event status register. 143
∗IDN?
Queries manufacturer's name, model name, and software version. 144
∗
RST
Performs device initial setting. 144
∗TST?
Requests execution of, and queries the result of, the self test. 144
Command Explanation
Ref
page
:ESR0?
Queries Event Status Register 0. 148
:HEADer
Enables and disables headers for the response mes-
sages.
149
:HEADer?
Queries whether or not headers on response messages
are enabled.
149
:MODE
Sets the test mode. 150
:MODE?
Queries the test mode. 150
:STATe?
Queries the state. 150
:STARt
Starting a test. 151
:STOP
Forcibly ends a test and releases the hold state. 151
:CONFigure:WITHstand?
Queries the contents of the set-value for withstand-volt-
age tests.
152
:CONFigure:WITHstand:KIND
Sets the type of voltage for withstand-voltage tests. 153
:CONFigure:WITHstand:KIND?
Queries the type of voltage for withstand-voltage tests. 153
:CONFigure:WITHstand:VOLTage
Sets the test-voltage value for withstand-voltage tests. 154
:CONFigure:WITHstand:VOLTage?
Queries the test-voltage value for withstand-voltage
tests.
154
:CONFigure:WITHstand:CUPPer
Sets the upper-limit test value for withstand-voltage
tests.
154
:CONFigure:WITHstand:CUPPer?
Queries the upper-limit test value for withstand-voltage
tests.
154
:CONFigure:WITHstand:CLOWer
Sets the lower-limit test value for withstand-voltage
tests.
155
:CONFigure:WITHstand:CLOWer?
Queries the lower-limit test value for withstand-voltage
tests.
155
:CONFigure:WITHstand:TIMer
Sets the test time for withstand-voltage tests. 155
:CONFigure:WITHstand:TIMer?
Queries the test time for withstand-voltage tests. 155
:CONFigure:WITHstand:UTIMer
Sets the ramp-up time for withstand-voltage tests. 156
:CONFigure:WITHstand:UTIMer?
Queries the ramp-up time for withstand-voltage tests. 156
:CONFigure:WITHstand:DTIMer
Sets the ramp-down time for withstand-voltage tests. 156
:CONFigure:WITHstand:DTIMer?
Queries the ramp-down time for withstand-voltage tests. 156
:CONFigure:WITHstand:VINItial
Sets the initial voltage for ramp-up for withstand-voltage
tests.
157
:CONFigure:WITHstand:VINItial?
Queries the initial voltage for ramp-up for withstand-volt-
age tests.
157