7.1 Saving the Test Conditions
99
7
Up to 8 conditions can be saved for the withstanding and insulation-resistance
tests respectively. Refer to "7.2 Loading the Test Conditions" (p. 102) on how to
load these data.
The settings for optional functions and status out will still be saved even when
the power is switched off, but they will not be saved as individual test informa-
tion.
Saved items in
the withstand-
voltage test
test-voltage frequency (50 Hz AC/60 Hz AC), test-voltage value,
upper-limit test value, lower-limit test value, test-time, ramp-up time,
ramp-down time, initial voltage for ramp-up, contact check upper-limit voltage,
contact check lower-limit voltage
Saved items in
the insulation-
resistance test
test-voltage value, lower-limit test value, upper-limit test value, test-time,
delay time, contact check upper-limit voltage, contact check lower-limit voltage
Saving / Loading
test conditions Chapter 7
7.1 Saving the Test Conditions
When the Save setting is set to OFF, OFF will be saved. Changing the setting to
ON using the ON/OFF key under the READY mode will also save the setting at
the same time.
To Next Page
Loading...
