3.1 Setting the Test-Conditions
34
When the test time timer is set, the test will automatically run and stop when the
time is up. If no test-time timer is required, set it to “OFF” using the ON/OFF key.
3.1.3 Setting the Test Time Timer
1.
Press the key to move the flashing cursor to the test-time timer.
2.
Press the / keys to set the test-time timer.
Setting range: 0.3 to 999 s
• When the set time scale is 0.3 s to 99.9 s
The value changes by 0.1 s. To change the value by 1 s, while holding down
the SHIFT key, press /
keys.
• When the set time scale is 100 s to 999 s
The value changes by 1 s. To change the value by 10 s, while holding down
the SHIFT key, press /
keys.
If no test-time timer is required, set it to “OFF” using the ON/OFF key.
3.
Press the STOP key to complete the setting value.
The instrument reverts to the READY state.
To continue to the setting for the next item, press the key.
or
<Ex.> Set to 0.3 s.
Set to OFF.
STOP
• The setting resolution of the test-time timer is 0.1 s between 0.3 and 99.9 s,
and becomes 1 s between 100 and 999 s.
• If a test-time timer has been set, the reduction timer will operate during the
test.
• If the test-time timer is set to OFF, the time elapsed during the test is dis-
played. When this time exceeds 999 s, "- - -" will appear, but the test will con-
tinue.
To Next Page
Loading...
