Hitachi P-N23NA2 Service Manual

6 Optional functions
Optional functions through Remote control
SMGB0099 rev.0 - 12/2016
222
F3 – Automatic reset of setting temperature
This function is used to economize the operation. When this function is activated, in the case that the set temperature
has not been changed for the time period congured by F4 (Automatic reset time), the set temperature automatically
returns to F5 (Automatic reset temperature for Cooling) or F6 (Automatic reset temperature for heating).
However, the temperature conguration does not perform the automatic Reset when operating in Automatic COOL/HEAT
mode or operations using the remote control for the central unit are forbidden.
Setting temperature
change
Setting temperature
change
Return to
F5
(Automatic reset
temperature for cooling)
Return to
F6
(Automatic reset
temperature for heating)
F4
(Automatic reset time)
Operation mode:
COOL
DRY
FAN
Operation mode:
HEAT
A/C
COOL
HIGH
LOUV. ADJ
Meeting Room
MODE SPEED LOUV. TEMP
OK
?
25
A/C
COOL
HIGH
LOUV. ADJ
Meeting Room
MODE SPEED LOUV. TEMP
OK
?
20
A/C
COOL
HIGH
LOUV. ADJ
Meeting Room
MODE SPEED LOUV. TEMP
OK
?
25
The setting temperature is changed
from 25ºC to 20ºC by remote
control switch.
Cooling operation at 20ºC is
performed temporally.
If no operation is done for a dened
period, the setting temperature
returns to 25ºC automatically.
F4 – Automatic reset time
This function is used to set the automatic reset time with the temperature setting.
Setting condition Automatic reset time of setting temperature
00 30 minutes (Factory setting)
01 15 minutes
02 60 minutes
03 90 minutes
F5 – Automatic reset temperature for cooling
This function is used to set automatic temperature reset in FAN/COOL/DRY modes.
Setting condition Setting temperature for automatic reset
19 19ºC
20 20ºC
·
·
·
·
·
·
25 25ºC (Factory setting)
·
·
·
·
·
·
29 29ºC
30 30ºC

Hitachi P-N23NA2 Specifications

General

Brand	Hitachi
Model	P-N23NA2
Category	Air Conditioner
Language	English