6 Optional functions
Optional functions through Remote control
SMGB0099 rev.0 - 12/2016
223
6
F6 – Automatic reset temperature for heating
This function is used to set automatic temperature reset in HEAT mode.
Setting condition Setting temperature for automatic reset
17 17ºC
18 18ºC
·
·
·
·
·
·
21 21ºC (Factory setting)
·
·
·
·
·
·
29 29ºC
30 30ºC
F7 – Operation stoppage prevention by remote control switch operational error
? NOTE
Operation is stopped by pressing the run/stop switch for 3 seconds.
F8 – Lock function for operation mode selection
This function is used to prevent changes to the operating mode.
F9 – Lock function for temperature setting
This function is used to prevent changes to the temperature setting.
FA – Lock function for fan speed selection
This function is used to prevent changes to the fan speed.
Fb – Lock function for swing louver operation
This function is used to prevent changes to automatic louver operations.
FC – Cooling lower limit for setting temperature
This function is useful to set the temperature range in cooling mode. It enables the cooling range to be reduced for
conguration using the remote control.
An example is shown in the following gure:
Temperature range at cooling
(standard)
Min at cooling +1ºC
Min at cooling +10ºC
Possible to set temperature
by remote controller switch
Impossible to set temperature
by remote controller switch
Fd – Heating upper limit for setting temperature
This function is used to dene an upper temperature setting limit for the HEAT function. This function enables the heating 
range to be reduced for conguration using the remote control.
An example is shown in the following gure:
Temperature range at heating
(standard)
Min at heating -1ºC
Min at heating -10ºC
Possible to set temperature
by remote controller switch
Impossible to set temperature
by remote controller switch
FE – Not available
To Next Page
Loading...
Need help?
General
