7. Installation
3. Move the winch cable in position (see 7.11.2 Move the winch cable in position).
4. Pull the cable while slowly unwinding the cable at the same time.
Note
Make sure that there is always tension in the winch cable. If you don't then the cable will
tangle,
Caution
Use gloves when you pull the winch cable.
5. Turn the stop plates of the winch out of the way.
6. Push the forks of the clamp keys together and pull
the clamp keys out.
88 U.C30e.00.00.EN Version
To Next Page
Loading...