HOEFLON C30e - Troubleshooting; The Remote Control Cannot Connect with the Crane; The LED Does Not Flash; The LED Stops Flashing and Goes off

10.
Troubleshooting
10.1 The remote control cannot connect with the crane
10.1.1 The LED does not flash
There is a problem with the RC6.
1. Make sure that all the levers are in the central position.
2. Calibrate the RC6 if all the levers are in the central position (see 5.3.2 Calibration)
3. Do an inspection of the Connect button (A).
4. Speak to your your Hoeflon dealer if you still cannot connect.
10.1.2 The LED stops flashing and goes OFF
There is a problem with the compact crane. Speak to your Hoeflon dealer. Do not continue working.
10.2 Charging the 24V batteries
The crane will not start if the 24V batteries are empty. Charge the 24V batteries with the emergency charging
points.
The emergency charging points are at the rear of the crane, under the compartment cover.
User guide - C30e Compact crane 139