HOEFLON C30e - Attaching the Hook Block with 2 X Reeving

7. Installation
7.11.5 Attaching the hook block with 2 x reeving
1. Prepare the crane (see 7.11 Prepare the crane for use with the winch).
2. Set the remote control to use the winch (see 7.11.1 Identify the winch).
l
Set the Winch reeving factor to 2.
3. Move the winch cable in position (see 7.11.2 Move the winch cable in position).
4. Pull the cable while slowly unwinding the cable at the same time
5. Turn the holding plates out of the way.
6. Push the forks of the clamp keys together and pull
the clamp keys out.
92 U.C30e.00.00.EN Version