HOEFLON C30e - Move the Winch Cable in Position

7.11 Prepare the crane for use with the winch
11. Push the Back button (6) two times to go back to the Settings menu.
12. The winch is now identified.
7.11.2 Move the winch cable in position
6.5 V
21
Track state: Both enabled
Function mapping: Hoeflon
SETTINGS
W
inch reeving factor: 1
Winch state: On
1. Set the remote control to use the winch (see
7.11.1 Identify the winch).
2. Set the Winch reeving factor to 1.
3. Pull the cable while slowly unwinding the cable at
the same time
Caution
Make sure that there is ALWAYS tension in the winch cable.
Pull the cable tight with your hand when wind or unwind the cable.
Caution
Be very careful that your hand does not get caught when you wind or unwind the cable.
Caution
Use gloves when you pull the winch cable.
User guide - C30e Compact crane 85