10.3 Error codes - 20240206
Error code Description / comment Correction procedure
1 Connection between gateway 3 and gateway 1
lost
1. Stop the compact crane.
l
Turn the key to position 0.
l
Fully push the emergency
button IN.
2. Remove the battery charger.
3. Wait 5 minutes.
4. Do the correction procedure.
5. Start the compact crane.
l
Release the emergency stop.
l
Turn the key to position 1.
30 No attachment detected on boom Install an attachment on the boom.
31 Attachment on the boom unknown Install a correct (Hoeflon) attachment on the
boom.
32 No (valid) CAN device found on boom. RFID tag is
valid.
Connect the CAN plug from the attachment.
33 No (valid) RFID tag found on boom. CAN device is
valid or not needed.
Make sure that the attachment is installed
and locked correctly.
34 RFID tag and CAN device detected on the boom
but data does not match.
Make sure that a correct (Hoeflon)
attachment is installed.
35 No attachment detected on attachment (jib) Install an attachment on the attachment
(jib).
36 Attachment on attachment (jib) unknown Install a correct (Hoeflon) attachment on the
attachment (jib).
37 No (valid) CAN device found on attachment (jib).
RFID tag is valid.
Connect the plug from the attachment to the
jib.
38 No (valid) RFID tag found on attachment (jib).
CAN device is valid or not needed.
Make sure that the attachment is installed
and locked correctly on the jib.
39 RFID tag and CAN device detected on attachment
(jib) but data does not match.
Make sure that a correct (Hoeflon)
attachment is attached to the jib.
40 Outrigger angle slip detected since switch to
hoist mode on front left outrigger
Do a check of the friction in the outrigger
lock clutch.
41 Outrigger angle slip detected since switch to
hoist mode at front right outrigger
Do a check of the friction in the outrigger
lock clutch.
42 Outrigger angle slip detected since switch to
hoist mode at right rear outrigger
Do a check of the friction in the outrigger
lock clutch.
43 Outrigger angle slip detected since switch to
hoist mode at left rear outrigger
Do a check of the friction in the outrigger
lock clutch.
45 Jib3 winch pressure too low Do a check for leaks on the winch cylinder.
46 Jib3 winch pressure too high The load is too heavy. Reduce the load.
47 Double jib detected (jib 3 and jib 5).
48 Jib5 angle sensor invalid Do a check of the sensor connection.
User guide - C30e Compact crane 141
To Next Page
Loading...