Hologic QDR 4500 - Page 242

QDR

4500 Technical Manual
A-2
8. Follow the instructions on the screen to install system software. When prompted,
indicate model type for this installation.
9. Reboot the computer when the software instructs you to do so.
10. Answer "Yes" to initialize patient and QC databases.
11. At Hologic main menu, go to Utility, then Upgrade.
12. Insert the first disk of the Elite System Upgrade (V9.8).
13. Follow the instructions on the screen and reboot the computer when prompted.
14. At the Hologic main menu, go to Utility, then Service, then dbManagement, then
dbRecover.
15. Insert the last (or only) dBarchive disk into the drive and press Enter. Press Enter again
to do a complete database recovery.
16. Install the remaining dBarchive disks, if applicable, as prompted by the recovery
program.
17. Reinstall the Hologic V9.03 System Software after the dbRecover operation through
Utility/Upgrade.
18. At the Hologic main menu, go to Utility, then Upgrade.
19. Insert the first disk of the Elite System Upgrade (V9.8).
20. Follow the instructions on the screen and reboot the computer when prompted.
21. If applicable, Install the Version 9 System Software Patch disk through Utility/Upgrade.
22. Install option disks (i.e. U.S.Reference Database/NHANES, Forearm, Low Density
Spine) through Utility/Upgrade.
23. Install OnePage and background printing.
Verify that the port and spool settings in Windows printer properties are correct.
24. Perform five QC scans and inspect BMD, BMC, and Area plots.
25. Archive a phantom scan and restore the scan to the hard drive.
26. Perform dBarchive.