QDR
®
4500 Technical Manual
3-6
INSPECT FOR HIDDEN SHIPPING DAMAGE
Open all crates and boxes, and check for signs of hidden damage. Bring any damage discovered
to the attention of the customer's Shipping/Receiving department.
TAKE INVENTORY
Using the following check list, take inventory of the contents of all crates and boxes, and confirm
that all of the expected items have been received. Report any discrepancies to Hologic.
Installation Inventory Check List
(Quantities are one (1) each unless otherwise specified)
[ ] Main QDR 4500 Assembly [ ] Upper C-Arm Assembly
[ ] Computer and Keyboard [ ] VGA Monitor
[ ] Black & White or Color Printer [ ] Knee (Block) Elevation Pad
[ ] QDR Spine Phantom [ ] Foot Restraint
[ ] Tabletop Pad [ ] QDR 4500 User's Guide
[ ] Printer Manual [ ] Printer Paper (B & W or Color)
[ ] 3.5" Floppy Disks (2 boxes) [ ] System Power Cable
[ ] Key (for enabling X-rays) [ ] Miscellaneous Hardware Box
[ ] Miscellaneous Cables Box
MEASURE PATH TO FINAL DESTINATION
Contact the department receiving the unit, and request that a representative show you the room
where the unit is to be installed. As you make your way from the loading dock to the room,
measure all doorways and openings including any elevator on which you must travel. Look for
other obstacles (thresholds, steps, sharp corners, etc.) which could cause a problem during
transport.
A QDR 4500A, or QDR 4500SL, fits through any doorway at least 30 inches (76.2cm) wide and
81inches (206cm) high, and hallways 45 inches (114cm) wide. All measurements are inside
dimensions.
A QDR 4500W, or QDR 4500C, fits through any doorway or hallway at least 30" (76.2cm) wide,
and 81" (206cm) high. All measurements are inside dimensions.
Short Doorway
If a QDR 4500 (any model) must be moved through a doorway that is not at least 81" (206cm)
high, the table top can be removed. This allows the unit to fit through a doorway 79" (201cm)
high (inside dimension). See the instructions for removing the table top below.
To Next Page