Document 800-05662 Rev C 107
06/10
System Administration and Equipment
Handling
In this section:
• Working with Passwords and PINs, page 107
• Restoring Default Settings or Resetting the Dome or Lens, page 109
• Resetting the Scan, Dome or Camera, page 110
• Changing Dome Address, Protocol, Parity or Baud Rate, page 110
• Sending Common Commands to all Domes, page 111
• Handling and Cleaning Equipment, page 112
Working with Passwords and PINs
Enabling the User or Privacy Zone Login PIN
Note Even if the user or privacy zone login PIN is disabled, a password is still
required to enter the Admin Login/Password Settings menu.
1. Ensure you have manual control of the dome.
2. Press 75
Preset.
3. Enter the 4-digit PIN. The default is 1000.
4. Select 1 User Login PIN
Enabled or Disabled (default).