Honeywell ACUIX - Step 7: Install the Lower Dome Onto the Housing; Installing the In-Ceiling Lower Dome; Installing the Indoor or Outdoor Pendant Lower Dome; Figure 3-22 In-Ceiling Housing Lanyard Bracket

ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662 Rev C 59
06/10
Step 7: Install the Lower Dome onto the Housing
Installing the In-Ceiling Lower Dome
1.Clip the lanyard to the mounting post inside the housing.
2. Align the lower dome tab hooks with the three mounting posts on the housing.
3. Twist to lock the lower dome into the housing.
4. If applicable, continue the next steps to configure the dome.
Figure 3-22 In-ceiling Housing Lanyard Bracket
Installing the Indoor or Outdoor Pendant Lower Dome
1. Clip the lower dome lanyard to the housing bracket.
2. Confirm that the o-ring is in place around the lower dome and press the lower dome
into the housing
3. Tighten the screws to secure the lower dome to the housing.
4. If applicable, continue the next steps to configure the dome.
Clip the lanyard from the lower
dome to the bracket inside the
housing