Honeywell ACUIX - Opening the OSD with Special Preset 90; Opening a Submenu or Selecting a Menu; Exiting or Escaping from a Menu

To Next Page

To Previous Page

Before You Begin Configuring

Opening the OSD with Special Preset 90

Note To access any preset (special or programmed) press [preset number] 

Preset button on the controller.

1. Enter a password or skip to step 2.

a. If prompted, enter the 4-digit PIN (the default is 1000) to log in as User Level 1.

Move the joystick up or down to select numbers for each digit. Move the joystick

left or right to move between digits.

b. Press F5 (enter).

2. Press 90

 Preset.

The OSD display opens on the monitor.

Opening a Submenu or Selecting a Menu

To open a submenu or select a menu, either:

• Press a number beside the menu option. The numbers either toggle between the

available choices or opens another menu.

• Move the joystick up or down the menu and press F5 (enter).

Exiting or Escaping from a Menu

Note Depending on the protocol used, for example with the HJZTP controller, the

monitor displays different exit instructions.

Other manuals for Honeywell ACUIX