110
System Administration and Equipment Handling
Resetting the Scan, Dome or Camera
Resetting the Scan and Dome
Note Resetting the dome is the same as cycling the power to the dome. It does not
restore the factory defaults but preserves all of the dome setup information.
After you select this menu option, there is no warning before the reset begins.
Select 4 Diagnostics Options 7 Scan and Dome Reset.
Resetting the Camera Lens
Select 98 Preset.
Changing Dome Address, Protocol, Parity or Baud Rate
Changing the Address Using a DIP Switch
Note It is recommended for most installations that SW5–8 is kept ON during
normal operation so that the logical address cannot be changed from the
on-screen setup menus.
1. Locate switch SW5 position 8.
2. Carefully place the switch in the required position to set the dome address from
memory.
• (Default) Select ON to force the dome to read the information from the switches.
• Select OFF to allow changes to settings using the OSD.
To Next Page
Loading...
