ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662 Rev C 63
06/10
Before You Begin Configuring
Complete the following before configuring your ACUIX dome:
• Important Information about Controllers and Protocols, page 63
• Step 1: Prepare the Controller and Monitor for Use, page 64
• Step 2: Turn on the Dome and Find the Mechanical Home, page 64
• Step 3: (Optional) Learn about the HJZTP Joystick Controller, page 65
• Step 4: Learn How to Use the Special Presets, page 67
• Step 5: Open the OSD Menu and Start Configuring, page 69
Important Information about Controllers and Protocols
The ACUIX is compatible with the following controllers and protocols:
• HJZTP controller using the VCL, MAXPRO-mode or Diamond protocols
• HMAX082/HMAX162 Matrix Switcher and HKJMMTP controller using VCL UTP / coax
control protocol
• Pelco P and Pelco D third party protocols and controllers
• HEGS5000/5001 controller with Diamond protocol
• IntelliBus™ protocol
In general, protocols allow cross compatibility between products and manufacturers.
Because the ACUIX™ dome is designed to work with a variety of controllers, Digital Video
Recorders (DVRs) and other hardware, deciding what protocol to use when setting up a
system is challenging. It is also not possible to describe all the tasks using all combinations
of protocols and hardware. Therefore, this guide is a supplement to the hardware users
guides and are based on the use of the Honeywell HJZTP joystick controller.