Honeywell ACUIX - Setting the Auto Slow Shutter Limit; Turning Wide Dynamic Range (WDR) on or off; Turning Interlace Scanning on or off; Turning Image Stabilization (EIS) on or off

90
Configuration
Setting the Auto Slow Shutter Limit
1. Select 5 Camera Options 3 Video Setup  5 Auto Slow
Shutter Lim.
2. Select NTSC options: 1/60, 1/30, 1/15, 1/8, 1/4 (default), 1/2
HDXG cameras only.
Turning Wide Dynamic Range (WDR) ON or OFF
1. Ensure Auto Iris Mode is ON.
2. Select 5 Camera Options 3 Video Setup  6 Wide
Dynamic Range  ON or OFF (default).
HDXG cameras only.
Turning Interlace Scanning ON or OFF
1. Select 5 Camera Options  3 Video Setup  7 Interlace
Scanning.
The message This will Disable WDR & Motion
Detection. Are you sure that you want to do
this? displays.
2. Select Y (yes) to continue and N (no) to cancel.
3. Select ON to disable the WDR and motion detection features or
OFF (default) to keep these features enabled.
HDXG cameras only.
Turning Image Stabilization (EIS) ON or OFF
1. Select 5 Camera Options  8 Image Stabilization.
The message This will Disable Interlace Scanning
and Image Stabilization. Are you sure that you
want to do this? displays.
2. Select Y (yes) to continue or N (no) to cancel.
3. Select ON or OFF (default). If set to ON, the motion detection
feature is disabled.
When EIS is enabled, the digital zoom is
limited to 2x.
HDXG cameras only.
Task/Action with Default (HDXG Camera Models Only) Notes