80
Configuration
Configuring the Image Quality and Video Display Settings
Note The Camera Options menu is highly variable and camera model dependent.
Caution Only qualified technical personnel should use the Camera Options menu
to change configurations as these changes can make the recorded images
unusable.
Note Remember you access the OSD by pressing 90 Preset.
Turning the Start Up State Restore ON or OFF
1. Select 3 Control Options 4 Set Pan and Tilt Options 6
Pan Offset 7 Startup State Restore
2. Select
• OFF (default).
• ON to set the dome to return to the state of operation at the
last loss of power.
3. If you selected ON, the message Extreme Caution: This
will move the dome to previous shutdown
position on startup... displays.
Select Y (yes) to continue or N (no) to cancel.
Displaying Pan and Tilt Coordinates
1. Select 4 Diagnostic Options 1 Coordinates
2. Select ON to display the pan (azimuth) and tilt
(elevation/declination) along the bottom of the monitor or OFF
(default).
Task/Action (with Default) Notes
To Next Page
Loading...
