Honeywell Performance Series User Manual

Web Client Operation
203
Network Alarm are the alarm signals from the TCP/IP. You cannot select the sensor type or
anti-dither functions.
1. Click Net Alarm in the ALARM configuration interface.
2. The configuration of Net Alarm options is very similar to the configuration for Local
Alarms. Please see Configuring Local Alarms on page 200 for more information on setting
time periods and event actions.
3. Click OK to save the settings.
Figure 12-72 WEB - Net Alarm Configuration Interface
Configuring IPC External Alarms
IPC External Alarms are the alarm signals from a connected IP camera.
1. Click IPC External Alarm in the ALARM configuration interface.
2. The configuration of IPC External Alarm options is very similar to the configuration for
Local Alarms. Please see Configuring Local Alarms on page 200 for more information on
setting time periods and event actions.
3. Click OK to save the settings.

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet