Honeywell Performance Series User Manual

Performance Series Network Video Recorder User Guide
218
Customized Title
Check to enable Customized Title, which displays the customized title
on the video monitor.
Original Scale
Check to show channels in their original aspect ratio. Unselected
channels display in full screen.
Video Spot
Check to select VGA Output or HDMI Output. In the selected output, the
user operation is disabled and it only displays the playback.
Tour Configurations
In the Tour interface, you can set the Tour Interval, Window Split mode, Video Detection
Tour, and Alarm Tour modes.
Click the Tour tab in the DISPLAY configuration interface under System to open the Tour
configuration interface.
Figure 12-93 Tour Configuration Interface
Table 12-30 Display Tour Settings
Setting Description
Enable Check to enable the tour function.
Interval
Adjust the tour interval between channels. Select from 5s to 120s. The
default is 5s.
Window Split
Set the window mode and channel group. Depending on your NVR, it
can support up to a 1/4/8/9/16/25/36/64-window split.
Channel Group
Add channels to a channel group, and when the NVR starts a tour, the
tour starts only on the selected channels for the group.
Video Detection
Tour / Alarm Tour
Set the Video Detection Tour and Alarm Detection Tour window modes.
The NVR can support 1/8 window.
Custom Split Configurations

Honeywell Performance Series Specifications

General

IR Range	Up to 30m (98ft)
Weatherproof Rating	IP66
Power Supply	PoE (Power over Ethernet) IEEE 802.3af, 12 VDC
Image Sensor	1/2.8" CMOS
Vandal Resistance	IK10
Video Compression	H.265/H.264/MJPEG
Storage	MicroSD card slot (up to 256GB)
Network Connectivity	10/100 Mbps Ethernet