ILLUSTRATIONS 
Part. No. 2400M2501_6    Touchpoint Pro 
  189  Technical Handbook 
Figure 42.  Shielding with Metal Armour, Metal Junction Box and Metal Sensor Body  36 
Figure 43.  Shielding with no Armour, Metal Junction Box and Metal Sensor Body  36 
Figure 44.  Shielding with Metal Armour, Plastic Junction Box and Plastic Sensor Body  37 
Figure 45.  Shielding with no armour, Plastic Junction Box and Plastic Sensor Body  37 
Figure 46.  27 Ah Battery Terminal Assembly  38 
Figure 47.  Correct Battery Orientation  38 
Figure 48.  Battery Connections  39 
Figure 49.  Three Wire Device  40 
Figure 50.  Two Wire Loop Powered Device  41 
Figure 51.  Two Wire Device with a Barrier  41 
Figure 52.  Two Wire Device with Alternative Barrier  41 
Figure 53.  Two Wire Device with an Isolated Barrier  42 
Figure 54.  mV Bridge Catalytic Detector  42 
Figure 55.  Unsupervised Circuit  43 
Figure 56.  Supervised for Open Circuit  43 
Figure 57.  Supervised for Open and Short Circuit  43 
Figure 58.  ROM Connections  44 
Figure 59.  Controller’s Terminal Layout Map  45 
Figure 60.  Ring Network Connections  46 
Figure 61.  Ring Network – Dual Backplane  46 
Figure 62.  Representative Screen Connections  47 
Figure 63.  PSU Status Circuit  48 
Figure 64.  System Status Screen  49 
Figure 65.  Controller Cover Panel  52 
Figure 66.  Bus Interface Board (BIB) Fitting  52 
Figure 67.  Modbus RTU Interface Terminals  53 
Figure 68.  Six Modbus Configuration Options  54 
Figure 69.  Modbus BIB Jumper Default Settings  55 
Figure 70.  Panel Configuration Screen  56 
Figure 71.  Calibration Screen  61 
Figure 72.  Zero Calibration Screen  61 
Figure 73.  Enter Span Gas Concentration  61 
Figure 74.  Span Gas Calibration screen  62 
Figure 75.  Calibration Screen, Span  62 
Figure 76.  mA Calibration Screen  63 
Figure 77.  mA Zero Calibration  63 
Figure 78.  mA Span Calibration  64 
Figure 79.  Programmable Signal Parameters  65 
Figure 80.  Delete Configuration Screenshots  104 
Figure 81.  CCB Configuration Screen  105 
Figure 82.  Safe System Interaction Screen  105 
Figure 83.  Select Buzzer Screen  106 
Figure 84.  System Status Normal  109