HP 1660 Series User Manual

1313 Select Board Tests, then select Run. When the Board Tests are finished, select Done.
1414 Select Data Input Inspection. All lines should show activity. Select Done to exit the
Data Input Inspection.
If you have an HP 1660A-series Logic Analyzer ( no oscilloscope), go to step 18. If you have
an HP 1660AS-series Logic Analyzer, continue with step 15.
1515
Select Analy PV, then select Scope PV in the pop up menu. Select Functional Tests.
1616 Select one of the Scope PV tests.
You can run all of t he test s at one t ime by selecting All Test s, or you can run each t est
individually. For this example, select Data Memory Test.
Troubleshooting
To run the self-tests
5–20

HP 1660 Series Specifications

General

Category	Logic Analyzer
Glitch Trigger	Yes
Pattern Trigger	Yes
State Analysis	Yes
Transitional Timing	Yes
Trigger Modes	Edge, Pattern, Glitch