8. After the feed speed of the stapler/stacker is changed, the stapler/stacker driver rotates M1301
counter-clockwise again to disengage the upper and the lower disengagement rollers.
PS1301
Inlet roller
Paddle
Delivery tray
Upper delivery roller
Lower delivery
roller
Upper delivery guide
Delivery roller
Jogger guide
Figure 4-43 Staple-mode feed operation
9. After the trailing edge of the paper passes the inlet sensor (PS1301), the stapler/stacker driver
activates the clamp solenoid (SL1301). During the clamp-disengagement operation, the stamp
is disengaged from the paper so the paper becomes unattached.
PS1301
Inlet roller
Paddle
Delivery tray
Clamp
Upper delivery roller
Lower delivery
roller
Delivery roller
Jogger guide
Figure 4-44 Staple-mode feed operation
10. The stapler/stacker driver changes its control depending on whether the paper that was fed is
the last sheet of the job or not.
●
If it is not the last sheet of paper, go to steps 11 and 12, and then go back to step 7.
●
If it is the last paper, go to step 11.
ENWW Stapler/stacker system 175
manuals4you.commanuals4you.com
To Next Page
Loading...