Control panel message Description Recommended action
Insufficient memory to load fonts/data
<device> - To Continue Touch OK
The MFP does not have enough memory to
load the data (for example, fonts or macros)
from the location specified.
Touch OK to continue without this
information. If the message persists, add
more memory.
Jam in Document Feeder Media is jammed in the document feeder. Clear the jam.
If the message persists, make sure that the
ADF mylar sheet, the ADF pickup-roller
assembly, and the ADF separation pad are
installed correctly. If any of these
components is dirty or worn, replace the
component.
The ADF-read motor might be defective.
Observe the motor to see if it is rotating or
attempting to pull paper through the paper
path. You can use the scanner tests
(Troubleshooting > Scanner Tests) to
test this motor. Run the ADF read motor
test and the ADF read motor reverse test. If
the motor does not rotate, verify that
connector CN103 is seated correctly on the
scanner-controller PCA and that the
connector on the motor is seated correctly.
If the motor is defective, replace the ADF.
The ADF paper-present sensor might be
defective. Make sure that the sensor flag
can move freely. You can use the scanner
tests (Troubleshooting > Scanner Tests)
to test this sensor. Manually move the flag
and observe whether the status changes on
the control-panel display. If the status does
not change, make sure that the wiring for
the sensor is firmly seated. Clean or
replace the sensor if necessary.
Load envelope feeder <type> <size> - To
Use Another Tray, Touch OK
The envelope feeder is empty.
1. Load the envelope feeder.
2. Replace the tray 1 sensor lever
(PS105).
3. Replace the DC controller PCA.
Load Tray 1 <type> <size> The tray is empty or configured for a
different size than the size requested.
1. Make sure that the tray is loaded with
the media type and size that is
indicated.
2. Replace the tray 1 sensor lever
(PS105).
3. Replace the DC controller PCA.
Manually feed <type> <size> The specified job requires manual feed
from tray 1.
Load the requested media into tray 1.
To override the message, touch OK to use
a type and size of media that is available in
another tray.
Manually feed output stack Then touch
OK to print second sides
The first side of a manual duplex job has
printed and the MFP is waiting for a user to
insert the output stack to complete the
second side.
Insert the printed stack in the input tray,
and then touch OK.
Table 6-1 Control-panel messages (continued)
ENWW Control-panel messages 395
manuals4you.commanuals4you.com
To Next Page
Loading...