5. Click Start Replication Wizard. This takes you to the Select Target Appliance step.
TIP:
Click on the show/hide details link to check how many target appliances are permitted
and the number of target appliances that are currently configured. See
“Fan In, Fan Out and job concurrency” on page 77 for more information about the maximum
number of appliances that are supported.
6. Select a Target Appliance from the list and click Next.
NOTE:
If you want to select an appliance that is not yet on the list, click Add Target Appliance.
Enter the Target Appliance IP Address or fully qualified domain name. The default values
for the Command and Data Protocol Port Numbers are usually acceptable, but may be
edited if there is a conflict. Click Add Target Appliance.
Configuring and using replication92
To Next Page
Loading...
Need help?
General