HTA HT2800T - Page 127

HT2800T_en_c.doc Page 127 of 275
Injection
Synchro
The autosampler starts
sample preparation
The autosampler injects
the sample in the
injector
The autosampler
gives the “Start”
signal to the
analyzer
Normal
At the reception of the
“Ready” signal from the
analyzer
After ending sample
preparation the autosampler
checks again the presence
of the “Ready” signal from
the analyzer and then starts
the injection
At the beginning of the
syringe plunger
movement
Trigger
In liquid mode:
At the reception of the
“Ready” signal from the
analyzer. After ending
sample preparation it emits
a “SYNC-OUT” signal
In liquid mode:
When it receives an external
synchronism (SYNC-IN) it
starts the injection and stop
the “SYNC-OUT” signal
emission when the “Start”
signal is activated
In liquid mode:
At the beginning of the
syringe plunger
movement
In Headspace and SPME
mode:
As Normal
In Headspace and SPME
mode:
As Normal
In Headspace and
SPME mode:
As Normal
A-Start
At the reception of the
“Ready” signal from the
analyzer
After ending the sample
preparation the autosampler
checks again for the
presence of the “Ready”
signal from the analyzer and
then starts the injection
When the autosampler
touches the injector
D-Start
At the reception of the
“Ready” signal from the
analyzer
After ending the sample
preparation the autosampler
checks again for the
presence of the “Ready”
signal from the analyzer and
then starts the injection
At the end of the
syringe plunger
movement