HT2800T_en_c.doc Page 265 of 275
12.2.2.2 Vial labeling
•
Printer Specification:
•
Resolution:
•
600 dpi Thermal Transfer printer (Advised);
•
300 dpi Thermal Transfer printer (Minimum).
•
Label Specification:
•
Label dimensions:
•
20x37 mm (Advised);
•
20x38 mm (Maximum).
•
Label material:
•
Opaque blank adhesive label.
•
Printing orientation:
•
Print with Bar Code bar perpendicular to printing way.
12.2.2.3 Bar Code Specifications
Code type
Maximum characters readable
Code 128 7 alphanumeric characters
Interleaved 2 of 5 7 numeric characters
Code 93 7 numeric characters
UPC-E 7 numeric characters (fixed)
EAN 8 7 numeric characters (fixed)
The code type must be set by HTA Autosampler Manager. It is
advised to:
•
Use always code with checksum in order to detect possible reading errors.
•
Apply the Bar Code label on the vial, paying attention not to overlap it excessively.
•
Position the vial with the Bar Code label oriented toward the Bar code Reader Module
HT2800T. Avoid to position the vial with any eventual label overlap oriented toward Bar
Code Reader Module.
•
Set the Bar Code Reader Module HT2800T in order to activate only the reading of the
Code type used (for example if Code 128 is being used, enable only this Code type in
order to reduce the possibility of reading error).
•
Follow the indication of the Bar Code standards when you create it. In particular leave an
appropriate margin on the left and on the right of the Bar Code.
To Next Page
Loading...
