Operation Manual - Multicast
Quidway S3000-EI Series Ethernet Switches Chapter 5
Multicast VLAN Configuration
Huawei Technologies Proprietary
5-5
0
le
enable
enable IGMP Snooping.
rvice-type multicast
ernet 1/0/10 port to hybrid. Then join the port to VLAN 2, 3
face Ethernet 1/0/10
ype hybrid
tagged
port to hybrid. Then join the port to VLAN 2 and
ype hybrid
ntagged
/2 port to hybrid. Then join the port to VLAN 3 and
ype hybrid
ntagged
[Switch A] multicast routing-enable
[Switch A] interface Vlan-interface 1
[Switch A-Vlan-interface10] pim dm
[Switch A-Vlan-interface10] igmp enab
2) Configure switch B as follows:
# Enable IGMP Snooping
<Switch B> system-view
[Switch B] igmp-snooping
# Set VLAN 10 to multicast VLAN and
[Switch B] vlan 10
[Switch B-vlan10] se
[Switch B-vlan10] igmp-snooping enable
[Switch B-vlan10] quit
# Define the type of the Eth
and 10 with the tagged option for the port to carry VLAN tag when transmitting packets
of these VLANs.
[Switch B] inter
[Switch B-Ethernet 1/0/10] port link-t
[Switch B-Ethernet 1/0/10] port hybrid vlan 2 3 10
[Switch B-Ethernet 1/0/10] quit
# Define the type of the Ethernet 1/0/1
10 with the untagged option for the port to transmit packets of these VLANs without
carrying VLAN tag. Finally set the default VLAN ID of the port to VLAN 2.
[Switch B] interface Ethernet 1/0/1
[Switch B-Ethernet 1/0/1] port link-t
[Switch B-Ethernet 1/0/1] port hybrid vlan 2 10 u
[Switch B-Ethernet 1/0/1] port hybrid pvid vlan 2
[Switch B-Ethernet 1/0/1] quit
# Define the type of the Ethernet 1/0
10 with the untagged option for the port to transmit packets of these VLANs without
carrying VLAN tag. Finally set the VLAN ID of the port to VLAN 3.
[Switch B] interface Ethernet 1/0/1
[Switch B-Ethernet 1/0/2] port link-t
[Switch B-Ethernet 1/0/2] port hybrid vlan 3 10 u
[Switch B-Ethernet 1/0/2] port hybrid pvid vlan 3
[Switch B-Ethernet 1/0/2] quit
To Next Page
Loading...
