Huawei Quidway S3000-EI Series User Manual

Operation Manual - Network Protocol
Quidway S3000-EI Series Ethernet Switches Chapter 5
Access Management Configuration
Huawei Technologies Proprietary
5-4
5.3 Disp y
er w to display the
fect of
la and debug Access Management
Aft the above configuration, execute display command in any vie
current configurations of access management on the ports, and to verify the ef
the configuration.
Table 5-4 Display current configuration of access management
Operation Command
Display current configuration of
access management
display am [ interface-list ]
Display Port, IP address and
MAC addr
d [ interface
{ interface-na interface-type
interface-number } | mac | ip-addr ip ]
ess binding
display am user-bin
me |
mac-addr
5.4 Acce ur
I. Networking requirements
zation 2 to the port
nd organization 2
cannot communicate with each other.
II
ment globally.
[Quidway] am enable
solation between port 1 and port 2.
olate ethernet0/2
ss Management Config ation Example
Organization 1 is connected to the port 1 of the switch, and organi
2.The ports 1 and 2 belong to the same VLAN. Organization 1 a
II. Networking diagram
See Figure 5-1.
I. Configuration procedure
# Enable access manage
# Configures Layer 2 i
[Quidway-Ethernet0/1] am is

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English