Huawei Quidway S3000-EI Series User Manual

Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-10
3) Sending the configuration information to monitor terminal
Table 4-15 Sending the configuration information to monitor terminal
Device Configuration Default value Configuration description
Enable info-center
By default,
info-center is
enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to
monitor
- -
Set information
source
-
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the switch of the
corresponding module before
defining output debugging
information.
Switch
Enable the terminal
display function and
this function for the
corresponding
information
-
For Telnet terminal and dumb
terminal, to view the information,
you must enable the current
terminal display function using
the terminal monitor
command.
4) Sending the configuration information to log buffer.
Table 4-16 Sending the configuration information to log buffer
Device Configuration Default value Configuration description
Enable info-center
By default,
info-center is
enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to
logbuffer
-
You can configure the size of the
log buffer at the same time.
Switch
Set information
source
-
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the switch of the
corresponding module before
defining output debugging
information.
5) Sending the configuration information to trap buffer.

Huawei Quidway S3000-EI Series Specifications

General

Brand	Huawei
Model	Quidway S3000-EI Series
Category	Switch
Language	English