Huawei Quidway S5700 Series User Manual

If the NDP neighbor is normally established, you can run the display ndp interface command
to check information about the MAC address of the neighboring station and the number of the
interface on the neighboring station that is connected to the local interface.
<Quidway> display ndp interface gigabitethernet 0/0/1
Interface: GigabitEthernet0/0/1
Status: Enabled, Packets Sent: 116, Packets Received: 110, Packets Error: 0
Neighbor 1: Aging Time: 174(s)
MAC Address : 0018-8203-39d8
Port Name : GigabitEthernet0/0/1
Software Version: VRP 5.70 V100R006C00
Device Name : S5700
Port Duplex : FULL
Product Ver : S5700
If the NTDP neighbor is normally established, you can run the display ntdp command to check
the NTDP settings.
<Quidway> display ntdp
Network topology discovery protocol is enabled
Hops : 3
Timer : 10 min
Hop Delay : 200 ms
Port Delay: 20 ms
Total time for last collection:462ms
If device information is successfully collected through NTDP, you can run the display ntdp
device-list [ verbose ] command to view information lists of all the devices.
<Quidway> display ntdp device-list
The device-list of NTDP:
------------------------------------------------------------------------------
MAC HOP IP PLATFORM
------------------------------------------------------------------------------
0004-0004-0004 2 S5700
0003-0003-0003 1 S5700
0002-0002-0002 1 S5700
0001-0001-0001 0 S5700
If the cluster is established successfully, you can run the display cluster command to view
information about the HGMP cluster to which the device belongs, such as the cluster name and
ID of the management VLAN.
<HUAWEI_0.Quidway> display cluster
Cluster name:"HUAWEI"
Role:Administrator switch
management vlan id : 10
Cluster multicast MAC address : 0180-c200-000a(default)
Cluster auto-join : disabled
Handshake timer:10 sec
Handshake hold-time:60 sec
IP pool:10.1.1.1/24
No logging host configured
No SNMP host configured
No FTP server configured
No SFTP server configured
cluster-member ftp-timeout: 300 sec(default)
Cluster SNMP NAT capability : enabled
Cluster FTP NAT capability : disabled
There are 2 member(s) in the cluster, and 0 of them are down.
If the cluster is established successfully, you can run the display cluster candidates command
to view information about candidate switches, such as the MAC address and device type.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
96

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional