By default, the holdtime is 60 seconds. The holdtime must be at least three times the
interval for sending handshake packets.
l Enable candidate switches to automatically join a cluster.
Do as follows on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
cluster-autojoin
Candidate switches are enabled to automatically join the cluster.
l Set the aging time of the Disconnecting state for member switches.
Do as follows on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
cluster-discagingtime disconnect-aging-time
The aging time of member switches is set.
By default, no aging time is set. It indicates that the Disconnecting state of member
switches is not aged.
l Configure a multicast MAC address for the cluster.
Do as follows on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
cluster-multimac mac-address
A multicast MAC address is configured for the cluster.
By default, the multicast MAC address of the cluster is 01-80-C2-00-00-0A. For
details of the range of the multicast MAC addresses, refer to the Command
Reference.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
99
To Next Page
Loading...
