l Run the cluster-ftp command on the member switch to set up a connection with the
public FTP server of the cluster.
3. For the situation that a device out of the cluster accesses the FTP server (Member-2):
l Calculate the port number reserved on the administrator switch for the FTP protocol of
a certain member switch in the cluster.
l Run the FTP client program on the PC and create an FTP connection with the member
switch.
Data Preparation
To complete the configuration, you need the following data:
l Management VLAN ID of the cluster, that is 10
l IP address of VLANIF 10 that is 1.0.0.1/8 and a reachable route between VLANIF 10 and
the FTP server
l Address pool of the cluster, that is 10.0.0.0/8
l IP address of the administrator switch used in the cluster, that is 10.0.0.1/8
l Member-2 serving as the FTP server in the cluster with the member ID being 2
Procedure
Step 1 Configure a management VLAN.
# Create VLAN 10 on the device and add interfaces of the administrator switch and member
switches to VLAN 10.
# Configure the administrator switch.
<Quidway> system-view
[Quidway] sysname Administrator-1
[Administrator-1] vlan 10
[Administrator-1-vlan10] quit
[Administrator-1] interface gigabitethernet 0/0/1
[Administrator-1-GigabitEthernet0/0/1] port link-type trunk
[Administrator-1-GigabitEthernet0/0/1] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet0/0/1] quit
[Administrator-1] interface gigabitethernet 0/0/2
[Administrator-1-GigabitEthernet0/0/2] port link-type trunk
[Administrator-1-GigabitEthernet0/0/2] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet0/0/2] quit
[Administrator-1] interface gigabitethernet 0/0/3
[Administrator-1-GigabitEthernet0/0/3] port link-type trunk
[Administrator-1-GigabitEthernet0/0/3] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet0/0/3] quit
[Administrator-1] interface vlanif 10
[Administrator-1-Vlanif10] quit
# Configure member switch 1.
<Quidway> system-view
[Quidway] sysname Member-1
[Member-1] vlan 10
[Member-1-vlan10] quit
[Member-1] interface gigabitethernet 0/0/1
[Member-1-GigabitEthernet0/0/1] port link-type trunk
[Member-1-GigabitEthernet0/0/1] port trunk allow-pass vlan 10
[Member-1-GigabitEthernet0/0/1] quit
[Member-1] interface gigabitethernet 0/0/2
[Member-1-GigabitEthernet0/0/2] port link-type trunk
[Member-1-GigabitEthernet0/0/2] port trunk allow-pass vlan 10
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
120
To Next Page
Loading...
