Huawei Quidway S5700 Series - Page 334

NOTE
This parameter cannot be configured for FTP and DNS test instances.
l Run:
probe-failtimes times
The number of permitted maximum probe failures, that is, the threshold to trigger the trap
message, is set for the NQA test instance.
l Run:
records history number
The maximum number of history records is set for the NQA test instance.
l Run:
records result number
The maximum number of result records is set for the NQA test instance.
l Run:
sendpacket passroute
The NQA test is configured to send packets without searching for the routing table.
NOTE
This parameter cannot be configured for DNS test instance.
l Run:
set-df
Packet fragmentation is prohibited.
NOTE
This function can be configured only for the Trace test instances.
l Run:
send-trap { all | { owd-ds | owd-sd | probefailure | rtd | testcomplete |
testfailure } * }
The condition for triggering the trap message is configured.
l Run:
source-address ipv4 ip-address
The source IP address is set for the NQA test instance.
l Run:
source-interface interface-type interface-number
The source interface is configured for the NQA test instance.
NOTE
The source interface can be configured for ICMPtest instances.
l Run:
source-port port-number
The source port number is set for the NQA test instance.
NOTE
This parameter can be configured for UDP, SNMP, TCP, FTP, and HTTP test instances.
l Run:
test-failtimes times
The trap threshold for continuous probe failures is set for the NQA test instance.
l Run:
timeout time
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
323