Huawei Quidway S5700 Series User Manual

1. Configure Switch A as the NQA client.
2. Create and perform the FTP test on Switch A to check whether a connection between
Switch A and the FTP server can be set up and to check the time for downloading a file
from the FTP server.
Data Preparation
To complete the configuration, you need the following data:
l IP address of the FTP server
l Source IP address for the test
l FTP user name and password
l Operation file of the FTP test
Procedure
Step 1 Configure the IP addresses of Switch A and Switch B. The configuration details are not
mentioned here.
Step 2 Configure Switch B as the FTP server.
<SwitchB> system-view
[SwitchB] ftp server enable
[SwitchB] aaa
[SwitchB-aaa] local-user user1 password cipher hello
[SwitchB-aaa] local-user user1 service-type ftp
[SwitchB-aaa] local-user user1 ftp-directory flash:
[SwitchB-aaa] quit
Step 3 Configure an NQA FTP test on Switch A.
<SwitchA> system-view
[SwitchA] nqa test-instance admin ftp
[SwitchA-nqa-admin-ftp] test-type ftp
[SwitchA-nqa-admin-ftp] destination-address ipv4 10.1.1.2
[SwitchA-nqa-admin-ftp] source-address ipv4 10.1.1.1
[SwitchA-nqa-admin-ftp] ftp-operation get
[SwitchA-nqa-admin-ftp] ftp-username user1
[SwitchA-nqa-admin-ftp] ftp-password hello
[SwitchA-nqa-admin-ftp] ftp-filename test.txt
Step 4 Perform the test.
[SwitchA-nqa-admin-ftp] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-ftp] display nqa results test-instance admin ftp
NQA entry(admin, ftp) :testflag is inactive ,testtype is ftp
1 . Test 1 result The test is finished
SendProbe:1 ResponseProbe:1
Completion :success RTD OverThresholds number: 0
MessageBodyOctetsSum: 448 Stats errors number: 0
Operation timeout number: 0 System busy operation number:0
Drop operation number:0 Disconnect operation number: 0
CtrlConnTime Min/Max/Average: 438/438/438
DataConnTime Min/Max/Average: 218/218/218
SumTime Min/Max/Average: 656/656/656
Average RTT:656
Lost packet ratio:0 %
----End
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
337

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional