EasyManua.ls Logo

Huawei Quidway S5700 Series - Page 356

Huawei Quidway S5700 Series
415 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 6-8 Networking diagram for configuring the traceroute test
SwitchA
GE0/0/1
VLANIF100
10.1.1.1/24
VLANIF100
10.1.1.2/24
VLANIF110
10.2.1.2/24
VLANIF110
10.2.1.1/24
GE0/0/1 GE0/0/1GE0/0/2
SwitchCSwitchB
Configuration Roadmap
The configuration roadmap is as follows:
1. Configure Switch A as the NQA client.
2. Create and perform the traceroute test on Switch A to check the statistics on each hop from
Switch A to Switch C.
Data Preparation
To complete the configuration, you need the following data:
l Destination address for the traceroute test
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Create an NQA traceroute test on Switch A and set the destination IP address to 10.2.1.2.
<SwitchA> system-view
[SwitchA] nqa test-instance admin trace
[SwitchA-nqa-admin-trace] test-type trace
[SwitchA-nqa-admin-trace] destination-address ipv4 10.2.1.2
Step 3 Perform the test.
[SwitchA-nqa-admin-trace] start now
Step 4 Verify the test result.
# Verify the NQA test result on Switch A.
[SwitchA-nqa-admin-trace] display nqa results test-instance admin trace
NQA entry(admin, trace) :testflag is inactive ,testtype is trace
1 . Test 1 result The test is finished
Completion:success Attempts number:1
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Drop operation number:0
Last good path Time:2006-8-5 14:38:58.5
1 . Hop 1
Send operation times: 3 Receive response times: 3
Min/Max/Average Completion Time: 46/47/41
Sum/Square-Sum Completion Time: 125/5349
RTD OverThresholds number: 0
Last Good Probe Time: 2006-8-5 14:38:58.3
Destination ip address:10.1.1.2
Lost packet ratio: 0 %
2 . Hop 2
Send operation times: 3 Receive response times: 3
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
345

Table of Contents

Related product manuals