Huawei Quidway S5700 Series User Manual

Data Preparation
To complete the configuration, you need the following data:
l Host address and mask of the NQA server
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure LDP on Switch A, Switch B, and Switch C. (The detailed procedure is not mentioned
here.)
For the configuration of LDP, refer to the Quidway S5700 Series Ethernet Switches
Configuration Guide - MPLS.
Step 3 # Configure Switch A.
# Enable the NQA client and create an LSP Ping test for a common tunnel.
<SwitchA> system-view
[SwitchA] nqa test-instance admin lspping
[SwitchA-nqa-admin-lspping] test-type lspping
[SwitchA-nqa-admin-lspping] lsp-type ipv4
[SwitchA-nqa-admin-lspping] destination-address ipv4 3.3.3.9 lsp-masklen 32
Step 4 Perform the test.
[SwitchA-nqa-admin-lspping] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-lspping] display nqa results test-instance admin lspping
NQA entry(admin, lspping) :testFlag is inactive ,testtype is lspping
1 . Test 1 result The test is finished
Send operation times: 3 Receive response times: 3
Completion:success RTD OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Min Positive Jitter: 0 Min Negative Jitter: 0
Max Positive Jitter: 0 Max Negative Jitter: 0
Positive Jitter Num: 0 Negative Jitter Num: 0
Positive Jitter Sum: 0 Negative Jitter Sum: 0
Positive Jitter Square Sum: 0 Negative Jitter Square Sum: 0
Packet Loss: 0 Packet Loss Ratio: 0
Destination ip address:3.3.3.9
Min/Max/Average Completion Time: 1/1/1
Sum/Square-Sum Completion Time: 3/3
Last Good Probe Time: 2009-2-1 15:32:56.1
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 100
#
mpls lsr-id 1.1.1.9
mpls
#
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
357

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional