Huawei Quidway S5700 Series - Page 377

[PE-A-nqa-test-pwe3ping] test-type pwe3ping
[PE-A-nqa-test-pwe3ping] local-pw-id 100
[PE-A-nqa-test-pwe3ping] local-pw-type vlan
[PE-A-nqa-test-pwe3ping] label-type control-word
Step 3 Perform the test.
[PE-A-nqa-test-pwe3ping] start now
Step 4 Verify the test result.
After running the display nqa results command on the PE device, you can see that the test is
successful.
[PE-A-nqa-test-pwe3ping] display nqa results
NQA entry(test, pwe3ping) :testflag is inactive ,testtype is pwe3ping
1 . Test 1 result The test is finished
Send operation times: 3 Receive response times: 3
Completion:success OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Min Positive Jitter: 0 Min Negative Jitter: 0
Max Positive Jitter: 0 Max Negative Jitter: 0
Positive Jitter Num: 0 Negative Jitter Num: 0
Positive Jitter Sum: 0 Negative Jitter Sum: 0
Positive Jitter Square Sum: 0 Negative Jitter Square Sum: 0
Packet Loss: 0 Packet Loss Ratio: 0
Destination ip address:10.2.2.2
Min/Max/Average Completion Time: 60/110/86
Sum/Square-Sum Completion Time: 260/23800
Average Single-Way Completion Time: 30
Last Good Probe Time: 2008-9-29 14:35:43.2
----End
Configuration Files
l Configuration file of CE-A
#
sysname CE-A
#
vlan batch 110
#
interface Vlanif110
ip address 100.1.1.1 255.255.255.0
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
return
l Configuration file of PE-A
#
sysname PE-A
#
mpls lsr-id 192.2.2.2
mpls
#
mpls l2vpn
#
mpls ldp
#
mpls ldp remote-peer 192.3.3.3
remote-ip 192.3.3.3
#
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
366