LLDP Message Tx Interval :30 (default is 30s)
LLDP Message Tx Hold Multiplier :4 (default is 4)
LLDP Refresh Delay :2 (default is 2s)
LLDP Tx Delay :2 (default is 2s)
LLDP Notification Interval :5 (default is 5s)
LLDP Notification Enable :enabled (default is disabled)
Management Address :IP: 10.10.10.1
Remote Table Statistics:
Remote Table Last Change Time :0 days, 0 hours, 0 minutes, 0 seconds
Remote Neighbors Added :0
Remote Neighbors Deleted :0
Remote Neighbors Dropped :0
Remote Neighbors Aged :0
Total Neighbors :1
Port information:
Port information:
Interface GigabitEthernet0/0/1:
LLDP Enable Status :enabled (default is disabled)
Total Neighbors :1
Port ID subtype :interfaceName
Port ID :GigabitEthernet0/0/1
Port description :HUAWEI, Quidway Series, GigabitEthernet0/0/1 Interface
Port And Protocol vlan ID(PPVID) don't supported
Port VLAN ID(PVID) :1
VLAN name of VLAN 1: VLAN1
Protocol identity :STP RSTP/MSTP LACP EthOAM CFM
Auto-negotiation supported :Yes
Auto-negotiation enabled :Yes
OperMau :speed(1000)/duplex(Full)
Power port class :PD
PSE power supported :No
PSE power enabled :No
PSE pairs control ability:No
Power pairs :Unknown
Port power classification:Unknown
Link aggregation supported:Yes
Link aggregation enabled :No
Aggregation port ID :0
Maximum frame Size :1600
MED port information
Media policy type :Unknown
Unknown Policy :Yes
VLAN tagged :No
Media policy VlanID :0
Media policy L2 priority :0
Media policy Dscp :0
Power Type :Unknown
PoE PSE power source :Unknown
Port PSE Priority :Unknown
Port Available power value:0
# View the neighbor information of SwitchA.
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 2 LLDP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
65
To Next Page
Loading...
Need help?
General
