Huawei Quidway S5700 Series

To Next Page

To Previous Page

3. Enable SwitchA and SwitchB to process LLDP BPDUs.

4. Configure management addresses for SwitchA and SwitchB.

Data Preparation

To complete the configuration, you need the following data:

l Management address 10.10.10.1 for SwitchA and management address 10.10.10.2 for

SwitchB

l Number of the Eth-Trunk between SwitchA and SwitchB, and numbers of the interfaces

added to the Eth-Trunk

Procedure

Step 1 Configure the Eth-Trunk between SwitchA and SwitchB.

# Configure SwitchA.

<Quidway> system-view

[Quidway] sysname SwitchA

[SwitchA] vlan batch 100

[SwitchA] interface eth-trunk 1

[SwitchA-Eth-Trunk1] trunkport gigabitethernet 0/0/1

[SwitchA-Eth-Trunk1] trunkport gigabitethernet 0/0/2

[SwitchA-Eth-Trunk1] trunkport gigabitethernet 0/0/3

[SwitchA-Eth-Trunk1] port link-type trunk

[SwitchA-Eth-Trunk1] port trunk allow-pass vlan 100

[SwitchA-Eth-Trunk1] quit

# Configure SwitchB.

Same as the configurations on SwitchA.

Step 2 Enable global LLDP on SwitchA and SwitchB.

# Configure SwitchA.

[SwitchA] lldp enable

# Configure SwitchB.

Same as the configurations on SwitchA.

Step 3 Enable SwitchA and SwitchB to process LLDP BPDUs.

# Configure SwitchA.

[SwitchA] interface eth-trunk 1

[SwitchA-Eth-Trunk1] bpdu enable

[SwitchA-Eth-Trunk1] quit

# Configure SwitchB.

Same as the configurations on SwitchA.

Step 4 Configure management addresses for SwitchA and SwitchB.

# Configure SwitchA.

[SwitchA] lldp management-address 10.10.10.1

# Configure SwitchB.

Quidway S5700 Series Ethernet Switches

Configuration Guide - Network Management 2 LLDP Configuration

Issue 01 (2011-10-26) Huawei Proprietary and Confidential

Huawei Quidway S5700 Series - Page 84