Huawei Quidway S5700 Series User Manual

Procedure
l Enabling NDP in the system view
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run:
ndp enable
By default, NDP is enabled in the system view.
l Enabling NDP on an interface
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run the following command as required:
– Run:
ndp enable interface { interface-type interface-number [ to interface-
type interface-number ] }&<1-10>
NDP on an interface is enabled in the system view.
– Run:
interface interface-type interface-number
The interface view is displayed.
Run:
ndp enable
NDP is enabled on the interface.
l (Optional) Setting the aging time of NDP packets
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run:
ndp timer aging aging-time
The aging time of NDP packets is set.
By default, the aging time of NDP packets is set to 180 seconds. The aging time of
NDP packets must be longer than the interval for sending NDP packets.
l (Optional) Setting the interval for sending NDP packets
Do as follows on the administrator switch and member switches:
1. Run:
system-view
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
87

Huawei Quidway S5700 Series Specifications

General

Category	Switch
Operating Temperature	0°C to 45°C
Relative Humidity	5% to 95% (non-condensing)
Series	Quidway S5700
Forwarding Performance	Up to 96 Mpps
Ports	24 or 48 x 10/100/1000Base-T ports
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C
Fixed GE Ports	24 or 48
Uplink Ports	4 x GE SFP ports
Routing Protocols	RIP, OSPF, BGP
Management	SNMP, RMON, CLI, Web
VLAN	4094 VLANs
PoE	Optional