IAI PCON-CB series - Page 312

6. Parameter
6.1 Parameter
6-37 ME0342-4B
[61] Absolute Unit (Parameter No.83)
No. Name Unit Input range Default initial value setting
83 Absolute Unit -
0: Not in use,
1: Used
In accordance with actuator
Set 1 for simple absolute specification.
For the battery-less absolute specification, the factory default value is 1. Change the setting to 0
when using in incremental specification.
[62] Fieldbus operation mode (Parameter No.84)
This parameter is exclusively used for the controller of field network specification.
Check the applicable instruction manual number in [Section 4.4 Operation of Field Network
Type] and refer to each instruction manual.
[63] Fieldbus node address (Parameter No.85)
This parameter is exclusively used for the controller of field network specification.
Check the applicable instruction manual number in [Section 4.4 Operation of Field Network
Type] and refer to each instruction manual.
[64] Fieldbus baud rate (Parameter No.86)
This parameter is exclusively used for the controller of field network specification.
Check the applicable instruction manual number in [Section 4.4 Operation of Field Network
Type] and refer to each instruction manual.
[65] Network type (Parameter No.87)
This parameter is exclusively used for the controller of field network specification.
Check the applicable instruction manual number in [Section 4.4 Operation of Field Network
Type] and refer to each instruction manual.